 |
Impact Racing’s SXS SA was designed for the rigors of SXS use, and is
compatible with all popular forced air systems. It features a side mounted airintake with internal channeling to direct the air-flow to where it’s needed most. The redirected air helps to eliminate potential wind induced mic noise, when using a communication system. The forced air system also features an Impact Racing exclusive, adjustable valve. The valve allows for maximum adjustment of airflow from 0% to 100%. The included, clear poly-carbonate shield provides
protection from debris, with replacement shields available in Clear, Dark-Tint, and Silver-Chrome. The SXS SA helmet can be ordered with additional options installed, such as helmet skirts and communication systems by PCI or Rugged Radios. The SXS SA helmet is DOT compliant making it legal for use in the state of CA for off-road vehicle use. Not for competition use.
- Please carefully read, understand and adhere to the following information. Since your helmet is engineered to very exacting standards, correct care is vital to its proper functioning.
SHIELD HARDWARE: to insure proper shield fit and function, it is important to check the tightness of the shield pivot and shield positioning screws before every use. Tighten until screws are firmly seated, careful to not over tighten.
HELMET CHEEK FIT PADS: to change, remove or replace cheek fit pads, turn the helmet upside down and place thumb under cheek pad and ‘pinch’ thumb with fingers on exterior shell. This will prevent separating and helmet upholstery from the shell as you remove the cheek fit pad. With free hand, slowly pull the cheek fit pad away from the hook and loop interior starting at the corner. Replace with new cheek pad.
HELMET INNER LINER: after a race, wet fit pads and liner should be dried in the shade using a fan.
MINI CHAMP & VAPOR HELMET INSERTS: The helmet comes from the factory as a size large without an insert. To place insert into the helmet perform the following: Hold Helmet with base opening facing you. Carefully fold back hat band upholstery toward you around the entire circumference of the helmet. Insert a Quick-Fit insert at the rear of helmet first and continue to push insert in and smooth insert down around the entire crown of the helmet. Fold hat band liner back into position.
HELMET HARDWARE: all fastening hardware and straps should be checked regularly for strength and security. Keeping all components of the helmet clean and well cared for is very important. Even perspiration can compromise the effectiveness of the hardware and straps.
|
|
|